Risk Racing Lock-N-Load Transport System

The “Lock-N-Load” Moto Transport System securely holds your motocross bike in your trailer without the use of tie-down straps, floor anchors or wheel chocks. It takes an enormous amount of pressure off of the fork seals during transit, and it frees up valuable space allowing the transport of more motorcycles or gear. Additionally, the Lock-N-Load can quickly be removed from the trailer floor by unscrewing the 4 thumb screws leaving only the low profile mounting plates. Each plate has a “D” ring for additional anchor points on your trailer floor.

To operate the Lock-N-Load, rotate the knobs into the lock position and simply roll or ride your bike into the trailer until your foot pegs hit the open jaws of the Lock-N-Load. Then step on the upper jaws and they will automatically lock into place. To release your bike, simply rotate the knobs into the release position and step on the top jaws. This will automatically release the jaws and free your motorcycle. For additional safety, insert the attached locking pins prior to transport. You can replace the locking pins with pad locks for added security and a theft deterrent.

Features:

• Saves your fork seals
• No more straps or wheel chocks
• Load more bikes and gear in your truck, van or trailer
• Quick release from the trailer floor
• Extra trailer plates are available

Measurements: 

• Maximum height 49 cm 
• 46 cm between each post 
• 46.5 cm between each footing 

Max Bike weight 270lbs / 122.47kg

*Please note - Check with State Transport regulations for bike transport requirements*

Browse more

• Browse all Risk Racing
• Browse all Risk Racing Lock-N-Loads
• Browse all Tie Downs
• Browse all Wheel Chocks